Tape A
Start	Introduction
00:12:00	Chassis Introduction
00:13:30	Cutting the floor
00:14:30	Trimming gearbox mounting plates
00:17:15	Tidying up the back-end
00:19:45	Rear subframe details
00:21:45	Trimming the rear trailing arm
00:25:30	Drilling the rear subframe
00:26:45	Fitting the rear subframe
00:29:45	Diff. mounting
00:33:30	Fitting the trailing arms to the chassis
00:35:00	MacPherson strut dismantling
00:41:45	Front suspension description/breakdown
00:43:45	Attaching the rear trailing arms
00:48:45	Under the rear trailing arms
00:49:30	Attaching the floor
00:51:15	Dismantling the Macpherson struts
00:55:30	Potential Macpherson strut problems
00:58:30	Plus pack warning
00:59:15	Finishing off the rear trailing arms
01:02:15	Fitting the rear springs
01:03:30	Cutting the rear roll-over bar
01:08:45	The optional rear coilovers
01:10:45	Rear shock absorber placement
01:15:00	Petrol tank bits and pieces
01:17:15	Estate rear trailing arm details
01:18:30	Forming the rear panel
01:26:00	Fitting the rear panel
01:37:15	Rear panel corner details
01:45:00	Degassing the Sierra petrol tank
01:45:45	Fitting the Sierra petrol tank
01:51:00	Petrol tank
01:54:15	Forming the seat back panel
01:58:15	Fitting the seat back panel
02:09:45	Fitting the engine/gearbox
02:13:15	Checking the propshaft and gearbox
02:18:45	Gearbox clearance (snip, snip!)
02:19:15	Fitting the gearbox mounting
02:26:45	Fitting the injection engine
02:29:00	Assembling the sliding pillar suspension